[Logo] Anarduino and HopeRF Community Forum
  [Search] Search   [Recent Topics] Recent Topics   [Hottest Topics] Hottest Topics     [Groups] Back to home page 
[Register] Register / 
[Login] Login 
Messages posted by: murrayc2002
Forum Index » Profile for murrayc2002 » Messages posted by murrayc2002
Author Message
Hi I am trying to build a Smart home door bell receiver using an esp8266 (nodemcu) and a hope RFM69W. I have built my own code for this not using, but based on Kobuki's OOK Library https://github.com/kobuki/RFM69OOK. I have successfully managed to decode my 433MHz Doorbell so I know what data I am supposed to receive. I also have a RXB6 Receiver and am able to pickup the data no problem using it. However when I try to use my RFM69W, only when I hold the Door bell transmitter within a few inches of the Antenna do I seem to pickup the signal/get data out of Pin2/data pin (after playing with the fixed threshold figure). Even then the Data is not correct and does not match what it should be. I have attached the code I am using, ignore the button state I am actually using a Logic analyser to look at the Data out pin.

Any help would be much appreciated.



Many thanks

Murray
 
Forum Index » Profile for murrayc2002 » Messages posted by murrayc2002
Go to:   
Powered by JForum 2.1.9 © JForum Team